Re: transom and deck
› DELFTship forum › Hull modeling › transom and deck › Re: transom and deck
I create the transom by creating a new face. First make sure your boat is the way you like it. Model the stern so that it looks nice in profile view, ten model it so that it looks nice in the body plan. You now have a big hole in the stern, the hole is the part that should look nice. Then you ctrl-select the points on the edges around the hole. It’s important that you select them in order, like when you were a child and drew lines through points in a book to make a figure. Then you create a new face from the points. The new face will fit nicely on the side but you have one edge that will most likely run diagonal. You need to split this edge and adjust the new point to fit. You will also have to turn some points into corner points depending on how you want the transom to look.
/Hampus
Your account
Recent Topics
-
Saving reports in Word or Excel format
by
Berislav Tusek
1 week, 2 days ago -
Attaching keel to hull
by
Matthieu
2 weeks, 1 day ago -
Modeling the 1907 U.S. Brigantine Galilee
by
Terrance Egolf
2 weeks, 1 day ago -
HOW TO USE THAT SOFTWARE
by
mirmir
2 months, 1 week ago -
How to hide “Clipping Volume”
by
FredoVollmer
2 months, 1 week ago -
Offset surface with errors
by
Felsentreu
2 months, 2 weeks ago -
What are your System requirements?
by
Maarten
2 months, 3 weeks ago -
Center of Gravity
by
Raul
3 months ago -
Unfold view not saving?
by
bn75
3 months ago -
merge control curves
by
Felsentreu
3 months, 2 weeks ago