Re: Those damn’ chines
› DELFTship forum › Hull modeling › Those damn’ chines › Re: Those damn’ chines
September 8, 2012 at 21:22
#36231
Participant
Try to split the “border layer” into two layers Aft border and Fwd Border, eliminated any point that is just connected to two edges, that usually “messes” with the developability.
To be honest i have use delftship for ship a lot more complex than yours and I haven“t had problem.
Regards
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
1 month, 3 weeks ago -
Cylinder through curved deck
by
RuudN
1 month, 3 weeks ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 3 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
2 months, 3 weeks ago -
install problems
by
tcurdt
2 months, 3 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months ago -
Deck Camber
by
patmat41959
3 months ago -
Waterline
by
Mats Nyberg
4 months ago -
CAD Interface
by
Peter Mitchell
4 months ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 2 weeks ago