Re: table of offsets measurement and import
› DELFTship forum › Hull modeling › table of offsets measurement and import › Re: table of offsets measurement and import
December 30, 2012 at 05:40
#36468
Participant
Ok figured out how to take the measurements but my offset file is not importing like it should. Although, I found exporting and then importing an offset table from one of the sample file yields plots that look nothing like the originals.
Can anyone help?
Your account
Recent Topics
-
Revision/save history?
by
Jamie
23 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago