Re: Stem thickness and bottom board
› DELFTship forum › Hull modeling › Stem thickness and bottom board › Re: Stem thickness and bottom board
November 23, 2012 at 21:04
#36431
Participant
We all have been a beginner with Delftship, and I don’t forget how puzzled I was with it on the begining.
If you wish to improve, the secret is to read the manual again and to practice, again and again. And only once you’re sure you know the software you can design your real project. That’s why I draw more than ships. :silly:
Your account
Recent Topics
-
Revision/save history?
by
Jamie
51 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago