Re: Stem thickness and bottom board
› DELFTship forum › Hull modeling › Stem thickness and bottom board › Re: Stem thickness and bottom board
November 21, 2012 at 21:56
#36417
Participant
Thanks for your comment Sean. Interesting point. Since I do not have to make hydrostatic calculations for a wherry, it would probably not matter if there is a gap in the middle of the boat! The stem line on the model is in fact the rabbet line (where the plank touches the stem); therefore, plank development would presumably not be affected by the procedure you describe. Lets see what others have to say about this…
Jean-Paul
Your account
Recent Topics
-
Revision/save history?
by
Jamie
49 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago