Re: Stations waterlines and bullocks keep resetting
› DELFTship forum › Hull modeling › Stations waterlines and bullocks keep resetting › Re: Stations waterlines and bullocks keep resetting
December 13, 2010 at 02:57
#34486
Participant
Hi Joe,
After you do that, you have to click on the red circle below the X box in the upper right corner of the box to add or delete station, waterlines etc. If you just click on the X and close the box, the stations etc. will revert to whatever was there originally. The red circle should show a pop up “Close this Dialog”. Click on that, then close the box and then click save and then re=open the box and enter you new stations etc. After you enter your new data, click on the red circle again and then close the box and save the data.
Gil Fleming
Gil Fleming Yacht Design Ltd.
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 1 week ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago