Re: small planing hull/jetboat
› DELFTship forum › Hull modeling › small planing hull/jetboat › Re: small planing hull/jetboat
January 20, 2012 at 05:52
#35479
Participant
this would not work for a jet boat… it needs that flat triangle bit on the bottom. here is a picture of something similar. it should be possible to draw this on freeship and then develope plates right?
how would you build this boat you have drawn from aluminum? the bow section would be almost impossible in one piece. ive seen guys build these hulls that are in the pictures below in three pieces. hull bottom and two sides. all bent and formed with a break then welded together.
Attachments:
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
1 month, 3 weeks ago -
Cylinder through curved deck
by
RuudN
1 month, 3 weeks ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 3 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
2 months, 3 weeks ago -
install problems
by
tcurdt
2 months, 4 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months ago -
Deck Camber
by
patmat41959
3 months ago -
Waterline
by
Mats Nyberg
4 months ago -
CAD Interface
by
Peter Mitchell
4 months, 1 week ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 2 weeks ago