Re: single piece bottom hull plate
› DELFTship forum › Hull modeling › single piece bottom hull plate › Re: single piece bottom hull plate
September 3, 2010 at 18:53
#34255
Participant
I usually have about a 10^o ‘v’ dead-rise. I would like to still have one sheet for the bottom; bending it at the center line for the portions aft and not having a weld all the the way down the keel. Is that something DELFT can help me do? That is the way many aluminum jet boats are constructed for additional strength.
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 4 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 3 weeks ago