Re: Problems closing the transom
› DELFTship forum › Hull modeling › Problems closing the transom › Re: Problems closing the transom
November 22, 2012 at 21:24
#36428
Participant
The shapes of the hull are all right. But when trying to close the transom I run crasy because I always lost the last “frame” by closing with the close tool.
Now I did it consequently till the whole transom was closed. After that I set the corners and some points to knuckle and it was finished. The after shape was refound.
Thanks for respond.
All the best from Kanu-Werft
Klaus
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 3 weeks ago