Re: Please somebody help me. Simple question.
› DELFTship forum › Hull modeling › Please somebody help me. Simple question. › Re: Please somebody help me. Simple question.
As you’ve noted (Transform > Scale) doesn’t always result in exactly what you want with only 4 places after the decimal available and in DelftShip there appears to be no way around that limitation. In the past I’ve tried multiple iterations with very limited success.
I know this may sound weird but since a foot is smaller than a meter it follows that 0.0001′ is less of a variation than 0.0001m would be … so if you are willing to trust the units conversion you may be able to get just a scooch closer than otherwise possible.
Considering that getting a substantial boat built to the nearest centimeter (never mind a 1/10 of a millimeter) over its whole length/width may be good practice may I suggest you need not be so concerned?
Your account
Recent Topics
-
Revision/save history?
by
Jamie
11 hours ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago