Re: Plate development problem in free Delftship 4.38.130

DELFTship forum Hull modeling Plate development problem in free Delftship 4.38.130 Re: Plate development problem in free Delftship 4.38.130

#35298
AvatarMICHAEL KERR
Participant

Capture.JPG
In layer properties type in the names of the layers after each one hit the ENTER key, once entered, go to DISPLAY–>INTERIOR EDGES, your hull will be covered in a spider like web of lines, click on each plate and highlight the spider web, one at a time and press the Layer in the Layer Window ( you can sellect the different layers with the drop down arrow), eg hightlight the Bottom Layer, then bring up the layer in the window called Bottom Plate now that plate with be assigned to that layer, then hightlight the next plate and in the window bring up the next layer etc etc now just to make sure the plates have been assigned correctly go to Layer Properties and switch the layer off (VISABLE), switch each layer off in turn just to check.