Re: lcb midship and lwl
› DELFTship forum › Hydrostatics and stability › lcb midship and lwl › Re: lcb midship and lwl
The Hydrostatic report in it’s right top corner indicates which is the Midship section location.
Now Delft ship have two options for this either you can put a value defined by the user or indicate as the 1/2 of the design length
This can be done in the Project settings menu, there is a tag named Main Dimensions where you give the main dimensions as per project, the Length is ussually the length between perpendiculars at the maximum draft, however you can choose which length to use and the software will calculate the 0.5L as the Midship section or you can give a fix value and the software will consider it as the fix location of the Midship section.
Just keep in mind that all values will be refer to the origin X=0, Y=0, Z=0.
Hope this info helps.
Regards
Your account
Recent Topics
-
Revision/save history?
by
Jamie
10 hours, 21 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago