Re: Keels rudders and layer selection/deleting
› DELFTship forum › Hull modeling › Keels rudders and layer selection/deleting › Re: Keels rudders and layer selection/deleting
July 7, 2011 at 00:25
#34990
Participant
The nice thing about it not truly merging is that it remains possible to adjust the endpoints of lines of a surface or mesh when turning off other layers that share that coordinate.
Your account
Recent Topics
-
Revision/save history?
by
Jamie
10 hours, 15 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago