Re: Joining points with an edge
› DELFTship forum › Hull modeling › Joining points with an edge › Re: Joining points with an edge
May 17, 2011 at 14:13
#34884
Keymaster
Rather than try creating edge directly, you should add a new face to three or more points. If an edge doesn’t exist between two successive points it wil be created automatically for you.
Your account
Recent Topics
-
Revision/save history?
by
Jamie
10 hours, 37 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago