Re: Joining points with an edge
› DELFTship forum › Hull modeling › Joining points with an edge › Re: Joining points with an edge
May 20, 2011 at 21:22
#34895
Participant
As far as i can see the edges are where two faces meet, so in order to create an edge, you must have faces first, in other words, you can create edges if there are not faces present, so as Marve said, create the faces and the edges will be created automatically.
Best regards
Your account
Recent Topics
-
Revision/save history?
by
Jamie
10 hours, 52 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago