Re: Is exporting a regular offset table even possible?
› DELFTship forum › Feature requests › Is exporting a regular offset table even possible? › Re: Is exporting a regular offset table even possible?
April 21, 2010 at 18:50
#34054
Participant
Hi , you’ll find all these info at the DS Manual, section 6.3 on pages 19 to 22.
Basically,in the middle of the table are the half beam (breadth) for each stations. The last line is the stem (X coordinates), above half beam the stern (X coord.)and water lines. On the right of 1/2 breadth – we’ve 3 columns, the 1st and 2nd are the sheer (z and y coord.) the last one the profile at center (z coord) for each station.
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
1 month, 3 weeks ago -
Cylinder through curved deck
by
RuudN
1 month, 3 weeks ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 3 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
2 months, 3 weeks ago -
install problems
by
tcurdt
2 months, 4 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months ago -
Deck Camber
by
patmat41959
3 months ago -
Waterline
by
Mats Nyberg
4 months ago -
CAD Interface
by
Peter Mitchell
4 months, 1 week ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 2 weeks ago