Re: “Intersect two layer” in v2.6
› DELFTship forum › Hull modeling › “Intersect two layer” in v2.6 › Re: “Intersect two layer” in v2.6
October 10, 2011 at 19:44
#35236
Participant
It’s coming along! Is there a way to make the new edge one long continuous edge? It seem to be made up of many short edges over top of each other (maybe that is a result of my clipping and trimming job). I assume because of this new discontinuous edge I have many more leek points (~84). Should I care about the leek points?
Attachments:
Your account
Recent Topics
-
Revision/save history?
by
Jamie
9 hours, 42 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago