Re: Imported IGES-sufaces from SolidWorks are not trimmed
› DELFTship forum › Hull modeling › Imported IGES-sufaces from SolidWorks are not trimmed › Re: Imported IGES-sufaces from SolidWorks are not trimmed
February 22, 2013 at 01:37
#36538
Participant
Hi Fredrik,
I’ve been using SolidWork for a while. I don’t have a specific answer for you, but I would be interested in SW into Delftship. I have one project in SW that I was going to import but it was so easy to create from scratch in Delftship that I skipped over that.
I’ll try a few and post my results.
Ray
raytclark at netzero dot net
Your account
Recent Topics
-
Revision/save history?
by
Jamie
29 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago