Re: Imported IGES-sufaces from SolidWorks are not trimmed
› DELFTship forum › Hull modeling › Imported IGES-sufaces from SolidWorks are not trimmed › Re: Imported IGES-sufaces from SolidWorks are not trimmed
February 22, 2013 at 01:59
#36539
Participant
Delftship doesn’t import trimmed surfaces, you can recreate the intersction and then delete and trim the surface so that it joins properly without any leak points, its a bit of a pain with big surfaces. It is worth playing with the subdivisions of you export surface so that you do not get too many nodes to deal with.
Your account
Recent Topics
-
Revision/save history?
by
Jamie
1 hour, 45 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago