Re: help with table of offsets
› DELFTship forum › Hull modeling › help with table of offsets › Re: help with table of offsets
December 29, 2010 at 00:39
#34520
Participant
The forward contour line is the interseccion of the ships bow with each waterline, and is measured from the origin (in Delftship is the point X=0,) in some cases is the aft perpendicular, so measure longitudinally from X=0 to the interseccion of each of the waterlines with the ship’s bow.
The aft countor line is the inerseccion of the stern line with each waterline, pretty much same as forward but is refered to the stern of the ship.
Hope this info helps.
Regards
Your account
Recent Topics
-
Revision/save history?
by
Jamie
10 hours, 17 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago