Re: Help wanted to get started with Delftship
› DELFTship forum › Hull modeling › Help wanted to get started with Delftship › Re: Help wanted to get started with Delftship
February 19, 2011 at 05:19
#34684
Participant
What i did, was start “playing” with the icons, like inserting points. inserting faces and edges, in a blank space, so i could undertand the way the software “thinks” and after a while i understood the basics of the system and start developing the hulls, is a way to start, getting familiar with the software and then jump into modelling hulls.
Good luck
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
1 month, 3 weeks ago -
Cylinder through curved deck
by
RuudN
1 month, 3 weeks ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 3 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
2 months, 3 weeks ago -
install problems
by
tcurdt
2 months, 4 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months ago -
Deck Camber
by
patmat41959
3 months ago -
Waterline
by
Mats Nyberg
4 months ago -
CAD Interface
by
Peter Mitchell
4 months, 1 week ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 2 weeks ago