Re: Exporting stations in DXF with an offset for planking?
› DELFTship forum › Hull modeling › Exporting stations in DXF with an offset for planking? › Re: Exporting stations in DXF with an offset for planking?
August 29, 2012 at 15:24
#36195
Participant
I wonder if a scalar transformation by a scaling factor that is the ratio of B/2 minus plank thickness divided by B/2 in Y- direction and an analog one in the Z- direction by a scaling factor of Tdwl minus plank thickness divided by Tdwl wouldn’t do the job?
Or is this a too simplified, crude assumption?
Your account
Recent Topics
-
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
1 month, 3 weeks ago -
Cylinder through curved deck
by
RuudN
1 month, 3 weeks ago -
Exporting table of offsets
by
Peter Mitchell
2 months, 3 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
2 months, 3 weeks ago -
install problems
by
tcurdt
2 months, 3 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months ago -
Deck Camber
by
patmat41959
3 months ago -
Waterline
by
Mats Nyberg
4 months ago -
CAD Interface
by
Peter Mitchell
4 months ago -
Deck and Bulkhead layers changing Hydrostatics ?
by
orfoz
4 months, 2 weeks ago