Re: Entering offsets of a “round” transom
› DELFTship forum › Hull modeling › Entering offsets of a “round” transom › Re: Entering offsets of a “round” transom
January 12, 2011 at 00:18
#34559
Participant
I’m not sure if I got that correctly – you managed to get the Offset Data in Freeship, but the transom is not like you hoped it to be?
if that is the case – what is it like?
(I just tried exporting and importing offset data of a ship I had once made out of data of an old paper sheet with offsets – almost similar transom like yours. the chine of the transom was there, but the transom stern plate was left open. By extruding the edge I could easily close it)
greetings,
Maximilian
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 2 weeks ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago