Re: Easy way of creating frames and stringers?
› DELFTship forum › Hull modeling › Easy way of creating frames and stringers? › Re: Easy way of creating frames and stringers?
September 16, 2011 at 13:20
#35134
Participant
Hello,
in the Version of Delftship before the actual release (4.46.158) it has been possible to generate a new face via extrusion from a edge that is not a boundary edge. Unfortunately this capability is not available in the new version mentioned above. The calculation of the hydrostatic data has been interfered, if I did so, but therefore I have got the possibility to obtain the masses of any surface in the design model.
Is thre any possibility to withdraw the rule, which prevents from generating surfaces at any position? This would be an easier way to plan internal structures of a design.
Regards
Christof
Your account
Recent Topics
-
Modeling the 1907 U.S. Brigantine Galilee
by
Terrance Egolf
1 month ago -
install problems
by
tcurdt
1 month ago -
VCG and GM of Smit Rotterdam
by
DuncanH
1 month ago -
Revision/save history?
by
Jamie
1 month, 1 week ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
3 months, 2 weeks ago -
Cylinder through curved deck
by
RuudN
3 months, 2 weeks ago -
Exporting table of offsets
by
Peter Mitchell
4 months, 2 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
4 months, 2 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
4 months, 3 weeks ago -
Deck Camber
by
patmat41959
4 months, 3 weeks ago