Re: Developable Surfaces
› DELFTship forum › Hull modeling › Developable Surfaces › Re: Developable Surfaces
i know this is a while ago but maybe you still need help.
i had the same problem. what i would do is start at the back by hilighting the furtherest aft line then in perspective i try and line the next line forward and see if the two are paralel. if they are not i play around with dimensions until i have the shape i want and the two lines are paralel in perspective view. then i procede to the next line forward lining it up with the 2nd from the back and do the same.
i have attached some pictures of what i mean. the pictures are not starting at the back but at the middle. you will need to do this for every flat surface before plate developments will unfold with no stress. hope fully you can understand.
Your account
Recent Topics
-
Revision/save history?
by
Jamie
11 hours, 11 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago