Re: Delftship and Godzilla/Michlet
› DELFTship forum › Hull modeling › Delftship and Godzilla/Michlet › Re: Delftship and Godzilla/Michlet
Hi Leo & Guille1963,
My problem isn’t with Michlet, it works perfectly with the output from Delftship, with no changes to the export file. Does this mean that since I haven’t made any changes to the export file the Pressure, Resistance and Wave Analysis output I get, is rubbish!
My problem has been with Godzilla. I’ve worked through the examples and the manual and I still get the momentary flashing screen, although it stays longer than before. My out.mlt shows “error: Nothing to optimise. Check limits on parameters”. And the godzout.mlt shows “0.0,0.000000”.
Does this mean that the design I have is already optimised to the limit or does it mean that my input data needs a lot of scrutiny?
Your account
Recent Topics
-
Revision/save history?
by
Jamie
1 hour, 40 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago