Re: Curves and intersections don’t match
› DELFTship forum › Hull modeling › Curves and intersections don’t match › Re: Curves and intersections don’t match
I sometimes have the same problem. It seems to occur when intersecting the hull with another plane. In my case (see attached image file), adding a floor produces problems with the linesplan sections …. you can see that the second section is kinked upwards near the centreline and other sections have missing segments. If I uncheck “intesections” and “linesplan” for the floor the problem goes away.
If the floor is at the same location as the station then the calculated intersection line can show abnomalies. The solution is indeed to disable the layer for the calculation of intersection lines.
In most cases the intersection line of a floor/bulkhead would not provide any useful information.
Your account
Recent Topics

import excel to delftship and surface became twisted
by trangtun
1 hour, 37 minutes ago

Importing CSV/TXT coordinates as stations?
by a
1 hour, 56 minutes ago

starting at a blank page.
by Joe
2 weeks, 2 days ago

Complete Newbie Needs Help Starting Out
by JeanPaul
1 month, 1 week ago

Corner points appearing in model need help
by PBC
1 month, 2 weeks ago

Beginner seeks tutor
by Kirsch
2 months ago

Lines Plan – Header on pdf
by Anneler Ruedi
3 months, 2 weeks ago

Personal help
by Hans
3 months, 2 weeks ago

Solidworks &Delftship
by riccardosercia
3 months, 2 weeks ago

Stability criterion – bottom emersion angle
by Kruk
3 months, 3 weeks ago