Re: Create a listing hullform
› DELFTship forum › Hydrostatics and stability › Create a listing hullform › Re: Create a listing hullform
February 1, 2013 at 08:52
#36521
Participant
Jurgen, very nice work with that 40feet cantingkeel! I only suggest you to check the spreaders distribution 😉 .
Delftship free can perform heeled hydro but in a very basic way, and it will NOT do it over a range of heel angles, so the job can be done but being very patient. What I do usually is a simplified model having just the heeled hull and a 3Dpoint showing the CG position. All I do is rotate over “x” (heel), move up and down and trim (rotate over “y”) until CG vertically fits CB while displacement remain unchanged. Anyway, check this post for a Cp issue that DS shows when calculating hydro in symetrized objects:
Your account
Recent Topics
-
Revision/save history?
by
Jamie
46 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago