Re: Control points vanished
› DELFTship forum › Hull modeling › Control points vanished › Re: Control points vanished
March 12, 2013 at 21:42
#36608
Participant
Interesting! Fortunately the hull was so near finally faired that i had already exported the offsets.
So all was not lost, the hydrostatics was fine & displacement ok.
Anyway I have been lofting full size, a few small discrepancies here & there but on the whole pretty good. I was going to do this anyway but its saved my bacon.
Should finish tomorow then its start cutting molds out.
No wonder my hair has gone so grey.
Thanks for the advice! Next time i will be more careful!
Your account
Recent Topics
-
Revision/save history?
by
Jamie
1 hour, 3 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago