Re: Control points vanished
› DELFTship forum › Hull modeling › Control points vanished › Re: Control points vanished
March 12, 2013 at 04:40
#36607
Participant
Start again from scrap, take care on all steps.
control points are not allowed to vanish ( otherwise I’ll shoot them out ).
Only way possible for, is a deletion of edges or, a throw in the dustbin.
By the way I made a test sketch and brutalized it with the sillyest management of control curves that I could imagine: Nothing weird happened!
So, mate…
with regrets…
jurgen:
Your account
Recent Topics
-
Revision/save history?
by
Jamie
1 hour, 10 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago