Re: Control points on an arbitrary plane
› DELFTship forum › Hull modeling › Control points on an arbitrary plane › Re: Control points on an arbitrary plane
October 15, 2011 at 01:52
#35274
Participant
Oh, I see. I tried the points first but couldn’t remember a new face is generated from points not edges – stupid me…
Anyways, the box worked if only using one face of it. A rookie method, but still. I like your idea better since I finally “got it”. I’m going to try that soon.
As for the angles and orders, I kept rotating and undoing until it looked right. In fact, I ended up rotating around both axis in the same transform window prompt (-15 and -25 degrees I think). I wonder what the algorithm is as compared to doing them separate and in different orders? No need to answer, just thinking out loud…
All the best,
Petter
Your account
Recent Topics
-
Modeling the 1907 U.S. Brigantine Galilee
by
Terrance Egolf
1 month ago -
install problems
by
tcurdt
1 month ago -
VCG and GM of Smit Rotterdam
by
DuncanH
1 month ago -
Revision/save history?
by
Jamie
1 month, 1 week ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
3 months, 2 weeks ago -
Cylinder through curved deck
by
RuudN
3 months, 2 weeks ago -
Exporting table of offsets
by
Peter Mitchell
4 months, 2 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
4 months, 2 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
4 months, 3 weeks ago -
Deck Camber
by
patmat41959
4 months, 3 weeks ago