Re: Control points on an arbitrary plane
› DELFTship forum › Hull modeling › Control points on an arbitrary plane › Re: Control points on an arbitrary plane
Hello,
one important notice:
When you intersect two layers. set the accuracy to ‘highest’. I seems, that DS uses the internal edges for the calculation of the intersection lines, and these depend on the accuracy.
You can easily see this effect, when you intersect the default model (new model) with a horizontal plane at z=1 and insert the new points into the plane. Before, leave the hull as it is, but subdivide the controlnet of the plan several times in order to get a higher accuracy. Then perform the intersectoperation with low and highest accuracy, respectiveley. You will get two different intersection lines.
Test file is attached.
Regards
Klaus
Your account
Recent Topics

Control face deletion
by Axel
1 week, 4 days ago

language
by Furio Fabbri
1 week, 5 days ago

Generating damage case to calculate Probabilistic Damage Stability
by kmou.mns
2 months, 1 week ago

Getting creased edge to show on developed plates
by DW
3 months ago

Frames, machinery and furnitures while calculating stability
by Asim21
4 months ago

Offset Table import
by MBerlin
4 months, 3 weeks ago

Autofair Function
by Charlie
4 months, 3 weeks ago

Model Rainbow Warrior missing from database
by heyopey
6 months, 1 week ago

Resistance Analysis too low
by RaulPB
6 months, 2 weeks ago

howto make “squared curved” surface to a “round curved” surface
by flo
6 months, 2 weeks ago