Re: concave sections in between chine points
› DELFTship forum › Hull modeling › concave sections in between chine points › Re: concave sections in between chine points
July 5, 2012 at 16:06
#36093
Participant
Hello anyone from DELFTship… how about a different take… my original questions.
Any suggestion for using DelftSHIP? Is this even possible in this software?
I have attached a sample of my design… refer to post above.
thanks,
Eric
Your account
Recent Topics
-
Revision/save history?
by
Jamie
1 hour, 43 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago