Re: Catamaran
› DELFTship forum › Hull modeling › Catamaran › Re: Catamaran
October 23, 2010 at 11:18
#34390
Participant
Hi mido1960,
the following is from a previous reply by Marven regarding multihulls.
Start modelling your outrigger. This can either be symmetrical or asymmetrical.
Then translate it off the centerline and model the middle hull as a conventional hull on the centerplane. Due to the symmetry both the outrigger and the center (half) hull will be mirrored by Delftship to get your complete boat.
Mike
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 2 weeks ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago