Re: Can’t get draft information in hydrostatics!
› DELFTship forum › Hydrostatics and stability › Can’t get draft information in hydrostatics! › Re: Can’t get draft information in hydrostatics!
February 18, 2011 at 18:15
#34678
Participant
No,the picture didn’t work… It said fake path when I used the browser to chose it, and manually writing the path didn’t work neither.
Anyway, we found our leak point which was 0,007 (as far as I can remember) away from y=0. It was located at about the same height, maybe 0.5-1 m away from where the hydrostatics stopped calculating on the Z axis. In Freeship this was a green point between two grey points.
Changing the location of the leak point to y=0 instead of y = 0.007 gave us the information we needed.
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 1 week ago -
I never start with a blank project
by
Maarten
2 months, 1 week ago -
Thank you for helping out!
by
Maarten
2 months, 1 week ago