Re: Can’t get draft information in hydrostatics!
› DELFTship forum › Hydrostatics and stability › Can’t get draft information in hydrostatics! › Re: Can’t get draft information in hydrostatics!
February 9, 2011 at 21:39
#34655
Participant
Check for leak-points in that area. FreeShip or DelftShip will stop calculating hydrostatics if find leak point below calculating waterline. Set small step for draft range.
Or Try to change draft (small step at one time) in Project Settings and run hydrostatics report. See where it gives warning.
Check all points on center-line. See if Y=0 there. If not, correct it.
Your account
Recent Topics
-
HOW TO USE THAT SOFTWARE
by
mirmir
1 month ago -
How to hide “Clipping Volume”
by
FredoVollmer
1 month ago -
Offset surface with errors
by
Felsentreu
1 month, 1 week ago -
What are your System requirements?
by
Maarten
1 month, 2 weeks ago -
Center of Gravity
by
Raul
1 month, 3 weeks ago -
Unfold view not saving?
by
bn75
1 month, 3 weeks ago -
merge control curves
by
Felsentreu
2 months, 1 week ago -
How to model ‘boxy’ hulls?
by
Tops
2 months, 1 week ago -
I never start with a blank project
by
Maarten
2 months, 2 weeks ago -
Thank you for helping out!
by
Maarten
2 months, 2 weeks ago