Re: bulkhead creation

DELFTship forum Hull modeling bulkhead creation Re: bulkhead creation

#35579
N J Cook
Participant

I’ve never been able to create an edge inside a hull. Edge | Insert always seems to be greyed out. Attempts to extrude always end up with “No boundary edge selected”. How is it done, then?

Extruding a deck or transom from the hull edges is no problem, but how do you extrude a deck some way below the hull rail to leave an upstand?

Intersecting the face of a box means you can create a plane bulkhead anywhere, not just on defined stations.