Re: Adding Keel and Rudder to the Hull
› DELFTship forum › Hull modeling › Adding Keel and Rudder to the Hull › Re: Adding Keel and Rudder to the Hull
December 7, 2011 at 19:37
#35417
Participant
Your imported part appear on the coordinates (0,0,0) (usually the stern).
Find the place you whish to place it on (check for the points long the hull’s profile) and note the new coordinates.
Diselect all then ask the MOVE tool to move the concerned part to the new coordiantes.
NOTE: you can give the part an angle. With the MOVE tool you’ll find the rotation tool. With FreeShip, rotation are made with the point (0,0,0) for center. Then rotate first, then move the parts.
Your account
Recent Topics
-
Revision/save history?
by
Jamie
10 hours, 1 minute ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago