Re: A problem with parts and layer properties
› DELFTship forum › Hydrostatics and stability › A problem with parts and layer properties › Re: A problem with parts and layer properties
March 4, 2013 at 02:07
#36569
Participant
Add on to the post.
For a better comprehension: there is also a nonsense in the sectional areas diagram, in the original project it is linear and predictable for a cigar-like hullshape: when exported and re-used in the new project it becomes a tooth-saw nightmare, with points and sections of “0” wet area, not connected – apparently – to any plausible transition point in any layer.
If it could affect, the boat is centered on the base line, for a better handling of the drawing process, but still, it is on both projects.
It really draws me nut!
Arggh! Jurgen 54.
Your account
Recent Topics
-
Revision/save history?
by
Jamie
1 hour, 38 minutes ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
2 months ago -
Cylinder through curved deck
by
RuudN
2 months ago -
Exporting table of offsets
by
Peter Mitchell
3 months ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
3 months ago -
install problems
by
tcurdt
3 months, 1 week ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
3 months, 1 week ago -
Deck Camber
by
patmat41959
3 months, 1 week ago -
Waterline
by
Mats Nyberg
4 months, 1 week ago -
CAD Interface
by
Peter Mitchell
4 months, 2 weeks ago