My Tiny Bladder — All These Leaks and No Relief!
› DELFTship forum › Hull modeling › “Intersect two layer” in v2.6 › My Tiny Bladder — All These Leaks and No Relief!
October 11, 2011 at 17:34
#35252
Participant
Thing are coming along! I haven’t been able to clean up the leak points though. When I zoom way in, and I look at the new edge it is made up of two separate edges. Each of these edges are connected to alternating points along the line between the transom and hull. I assume this explains the 310 leak points in my most detailed model. Can I merge these two edges? I think that would end my challenges.
Thanks again, Dave
Attachments:
Your account
Recent Topics
-
Modeling the 1907 U.S. Brigantine Galilee
by
Terrance Egolf
1 month ago -
install problems
by
tcurdt
1 month, 1 week ago -
VCG and GM of Smit Rotterdam
by
DuncanH
1 month, 1 week ago -
Revision/save history?
by
Jamie
1 month, 1 week ago -
Create deck plane as the intections at z=xxx with the hull
by
Pidgee
3 months, 2 weeks ago -
Cylinder through curved deck
by
RuudN
3 months, 2 weeks ago -
Exporting table of offsets
by
Peter Mitchell
4 months, 2 weeks ago -
Modelling a flat bottom chine tug hull (WWII TID)
by
Paul
4 months, 3 weeks ago -
Correct Hull Shape from Existing Lines Plan
by
patmat41959
4 months, 4 weeks ago -
Deck Camber
by
patmat41959
4 months, 4 weeks ago